Main
Before building
- Week 25
- Week 26
- Week 27
- Week 28
- Week 29
- Week 30
- Week 31
- Week 32
- Week 33
- Week 34
- Week 35
- Week 36
- Week 37
- Week 38
- Week 39
- Day 118
- Day 119
- Day 120
- Day 121
- Week 40
- Week 41
- Week 42
- Week 43
- Week 44
- Week 45
- Week 46
- Week 47
- Week 48
- Week 49
- Week 50
- Week 51
- Week 52
- Week 53
- Week 54
- Week 55
- Week 56
- Week 57
- Week 58
- Week 59
- Week 60
- Week 61
- Week 62
After building
Day 120 - Finishing the seat mounts
|
I had a short day today; tomorrow, I'm going to Richfield seats to drop off the frames, and collect the GRP shells. The height of the back was pretty much fixed, but the front wasn't. I used some spare 50mm square plate, and some other bits to make the front mounts:
Actually mounting the back, I had to put a lot of thought into it - and I elected to use something similar to the other seats
However, this is more accessible than the passenger seats. And with that, I tidied everything up, and cleaned the body to prevent ground steel from creating rust spots (it's quite tight in my garage). |
Copyright © 2005-2007 Tribbeck.com / Jason Tribbeck